Final Check of SRS Using CONSULT-II-Diagnosis Mode

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Refer to "CONSULT-II START PROCEDURE ".

If no DTC is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 2.
If any DTC is detected on "SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Go to "DIAGNOSTIC PROCEDURE 2 ".

Fig 1: Identifying CONSULT-II Display - SELF-DIAG (Current)
Touch "ERASE".
NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").

If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.

Fig 2: Identifying CONSULT-II Display - SELF-DIAG (Current)
Touch "BACK" key of CONSULT-II to "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".

Fig 3: Identifying CONSULT-II Display - SELECT DIAG MODE
Check that no malfunction is detected on "SELF-DIAG [PAST]".
Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.
Turn ignition switch OFF then turn off and disconnect CONSULT-II.
Go to "DIAGNOSTIC PROCEDURE 1 ".

Fig 4: Identifying CONSULT-II Display - SELF-DIAG (PAST)