LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2046 (SRS Airbag) >> Spiral Cable >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
  • When servicing the SRS, do not work from directly in front of air bag module.
  1. Disconnect the negative and positive battery cables, then wait at least 3 minutes.
  2. Set the front wheels in the straight-ahead position.
  3. Remove the steering wheel. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove the column cover upper and lower.
  5. Disconnect wiper and washer switch connector. Then while pressing tabs, pull wiper and washer switch away from spiral cable to remove.
    Fig 1: Identifying Wiper And Washer Switch Connector
    G04902415
  6. Disconnect lighting and turn signal switch connector. Then while pressing tabs, pull lighting and turn signal switch toward driver door to remove.
    Fig 2: Identifying Lighting And Turn Signal Switch Connector
    G04902416
  7. Remove the screws. Then while pressing the tab, pull the spiral cable away from steering column assembly.
    CAUTION:
    • Do not disassemble spiral cable.
    • Do not apply lubricant to the spiral cable.
      Fig 3: Identifying Spiral Cable And Screw
      G04902417
  8. Disconnect the spiral cable connectors.
    CAUTION: With the steering linkage disconnected, the spiral cable may snap by turning the steering wheel beyond the limited number of turns. The spiral cable can be turned counterclockwise about 2.5 turns from the neutral position.
    Fig 4: Identifying Spiral Cable Connectors
    G04899524