LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2041 (Front Suspension) >> Upper Link >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire using power tool.
  2. Support the lower link using a suitable jack.
  3. For the LH side only, remove the bolt from the lower joint of the lower joint shaft, then reposition the lower joint shaft out of the way.
    CAUTION:
    • Do not damage the lower joint.
      Fig 1: Identifying Bolt (Lower Side) Of Lower Joint
      G04902303
  4. Remove cotter pin and nut from upper link ball joint.
  5. Separate upper link ball joint stud from steering knuckle using Tool.

    Tool number : ST29020001 (J-24319-01) 

    Fig 2: Separating Upper Link Ball Joint Stud From Steering Knuckle
    G04899083
  6. Remove upper link bolts and nuts.
    Fig 3: Identifying Upper Link Bolts And Nuts
    G04899158
scientia non olet · About LEMON Manuals