LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Engine Controls - Self-Diagnostics - 1.8L - Ca) >> Diagnostic Tests >> DTC P0107 Or DTC P0108: Barometric Pressure (BARO) Sensor >> DTC Confirmation Test

DTC Confirmation Test

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Malfunction is detected when PCM receives an excessively low or high voltage from BARO sensor. Possible causes are:

Connect Scan tool to Data Link Connector (DLC). See Figure . Turn ignition on. Using scan tool, select DATA MONITOR. Wait at least 10 seconds. If a first trip DTC is retrieved, perform DIAGNOSTIC PROCEDURE  . If DTC is not set, problem may be intermittent. See TESTING PROCEDURE  under SELF-DIAGNOSTIC SYSTEM.

scientia non olet · About LEMON Manuals