LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2039 (Rear Axle) >> Wheel Hub >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire assembly using power tool.
  2. Remove the rear brake caliper, without disconnecting the hydraulic hose, using power tool. Reposition the rear brake caliper aside using suitable wire. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
    NOTE: Do not depress the brake pedal while the brake caliper is removed.
  3. Remove the rear disc rotor.
  4. Remove the cotter pin, then remove the rear drive shaft nut using power tool.
    • Discard the cotter pin, use a new one for installation.
  5. Remove the rear drive shaft. Refer to "REMOVAL AND INSTALLATION ".
  6. Remove the four rear wheel hub and bearing assembly bolts using power tool.
    • Discard the four rear wheel hub and bearing assembly bolts, use new ones for installation.
  7. Remove the rear wheel hub and bearing assembly.
scientia non olet · About LEMON Manuals