Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear wheel sensor. Refer to "REMOVAL AND INSTALLATION " for VDC/TCS/ABS or "REMOVAL AND INSTALLATION " for HDC/HSA/VDC/TCS/ABS.
Remove the drive shaft from the rear final drive assembly. Refer to "REMOVAL AND INSTALLATION ".
Remove the side flange using Tools.
Tool numbers A: KV40104100 ( - )

B: ST36230000 (J-25840-A)

NOTE: Circular clip installation position: Rear final drive side

Fig 1: Identifying Side Flange
Remove the side oil seal using suitable tool.
CAUTION: Do not to damage gear carrier.

Fig 2: Identifying Side Oil Seal