LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2038 (Rear Final Drive) >> Carrier Cover >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a 3 mm (0.12 in) bead of sealant to the mating surface of the carrier cover as shown.
    • Use Genuine Silicone RTV or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".
      CAUTION: Remove any old sealant adhering to the mating surfaces. Also remove any moisture, oil, or foreign material adhering to the application and mating surfaces.
      Fig 1: Applying Sealant To Mating Surface Of Rear Cover
      G04901931
  2. Install the carrier cover to the gear carrier. Tighten the bolts to the specified torque. Refer to "COMPONENTS ".
  3. Install the rear final drive assembly. Refer to "REMOVAL AND INSTALLATION ".
    CAUTION: Fill the rear final drive assembly with recommended differential gear oil. Refer to "DIFFERENTIAL GEAR OIL ".
scientia non olet · About LEMON Manuals