LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2037 (Front Axle) >> Drive Shaft >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove wheel and tire using power tool.
  2. Remove rear engine under cover using power tool.
  3. Remove wheel sensor harness from mount on knuckle, then disconnect wheel sensor harness connector.
    CAUTION: Do not pull on wheel sensor harness.
  4. Remove wheel hub and bearing assembly. Refer to "REMOVAL AND INSTALLATION ".
    • It is not necessary to remove wheel sensor from wheel hub when wheel hub is not being replaced.
    • Carefully feed wheel sensor harness through hole in splash shield.
  5. Separate upper link ball joint stud from steering knuckle using Tool.
    • Support lower link with jack.

      Tool number : ST29020001 (J-24319-01) 

    Fig 1: Identifying Upper Link Ball Joint
    G04910849
  6. Remove drive shaft assembly.
scientia non olet · About LEMON Manuals