Removal and Installation: Installation

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Install the new front oil seal until it is flush with the end face of the front case using Tool.
Tool number : KV38100500 ( - )
CAUTION:
- Do not reuse oil seal.
- Apply petroleum jelly to oil seal.
  
  Fig 1: Tapping Front Oil Seal
Align the matching mark of the front drive shaft with the matching mark of the companion flange, then install the companion flange.

Fig 2: Aligning Matching Mark Of Front Drive Shaft
Install the new self-lock nut and tighten to the specified torque using Tool. Refer to "COMPONENTS ".
Tool number : KV40104000 ( - )

CAUTION: Do not reuse self-lock nut.

Fig 3: Tightening Self-Lock Nut
Install the front propeller shaft. Refer to "REMOVAL AND INSTALLATION ".
Refill the transfer with fluid and check for fluid leakage and fluid level. Refer to "TRANSFER FLUID ".