Component Inspection

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch "OFF". (Stay for at least 5 seconds.)
Remove clutch pressure switch. Refer to "LOCATION OF ELECTRICAL PARTS ".

Push and release clutch pressure switch and check continuity between transfer terminal cord assembly terminal 7 and ground.

CONNECTOR TERMINAL CONTINUITY REFERENCE

Terminal	Condition	Continuity
7 - Ground	Push clutch pressure switch	Yes
7 - Ground	Release clutch pressure switch	No

Fig 1: Checking Continuity Between Transfer Terminal Cord Assembly Terminal 7 And Ground

If NG, replace the clutch pressure switch. Refer to "LOCATION OF ELECTRICAL PARTS ".