LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2036 (Transfer Case) >> ATX14B >> Trouble Diagnosis For System >> Actuator Position Switch >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove transfer control device. Refer to "REMOVAL AND INSTALLATION ".
  2. Check operation by applying battery voltage to transfer control device (actuator motor) terminals 21 and 24.
    CAUTION:
    • Do not operate actuator motor for more than 1 second.
    • Change the actuator motor position to "HIGH" when installing.
    • Be careful not to overheat the harness.
    CONNECTOR TERMINAL VOLTAGE REFERENCE

    Terminal Continuity Continuity
    24 (Battery voltage) - 21 (Ground) 20 - 22 YES
    22 - 23 NO
    21 (Battery voltage) - 24 (Ground) 22 - 23 YES
    20 - 22 NO
    Fig 1: Applying Battery Voltage To Transfer Control Device (Actuator Motor) Terminals 21 And 24
    G04901507
  3. If NG, replace transfer control device. Refer to "REMOVAL AND INSTALLATION ".
scientia non olet · About LEMON Manuals