LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2036 (Transfer Case) >> ATX14B >> Transfer Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set transfer state as 2WD when 4WD shift switch is at 2WD.
  2. Remove the undercovers using power tool.
  3. Drain the transfer fluid. Refer to "DRAINING ".
  4. Remove the center exhaust tube and main muffler. Refer to "REMOVAL AND INSTALLATION ".
  5. Remove the front and rear propeller shafts. Refer to "REMOVAL " (front), "REMOVAL " (rear).
    CAUTION: Do not damage spline, sleeve yoke and rear oil seal when removing rear propeller shaft.
    NOTE: Insert a plug into the rear oil seal after removing the rear propeller shaft.
  6. Remove the A/T nuts from the A/T crossmember. Refer to "COMPONENTS ".
  7. Position two suitable jacks under the A/T and transfer assembly.
  8. Remove the crossmember. Refer to "COMPONENTS ".
    WARNING: Support A/T and transfer assembly using two suitable jacks while removing crossmember.
  9. Disconnect the electrical connectors from the following:
    • ATP switch
    • Neutral 4LO switch
    • Wait detection switch
    • Transfer motor
    • Transfer control device
    • Transfer terminal cord assembly
  10. Disconnect each air breather hose from the following. Refer to "REMOVAL AND INSTALLATION ".
    • Actuator
    • Breather tube (transfer)
    • Transfer motor
  11. Remove the transfer control device from the extension housing.
  12. Remove the transfer to A/T and A/T to transfer bolts.
  13. Remove the transfer assembly.
    WARNING: Support transfer assembly with suitable jack while removing it.
    CAUTION: Do not damage rear oil seal (A/T).
scientia non olet · About LEMON Manuals