Removal and Installation: Installation

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Install the new rear oil seal until it is flush with the end face of the rear case using Tool.
Tool number : ST30720000 (J-25405)
CAUTION:
- Do not reuse oil seal.
- Apply petroleum jelly to oil seal.
  
  Fig 1: Tapping Oil Seal Flush With End Face Of Rear Case
Apply petroleum jelly to the circumference of the new dust cover. Position the new dust cover using the identification mark as shown.
CAUTION:
- Do not reuse dust cover.
- Position the identification mark at the position shown.
  
  Fig 2: Identifying Identification Mark Position
Install the new dust cover to the rear case using Tool.
Tool number : KV40105310 ( - )
CAUTION:
- Do not reuse dust cover.
- Apply petroleum jelly to dust cover.
Install the rear propeller shaft. Refer to "REMOVAL AND INSTALLATION ".
Refill the transfer with fluid and check for fluid leakage and fluid level. Refer to "TRANSFER FLUID ".