Propeller Shaft Vibration

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

If a vibration is present at high speed, inspect the propeller shaft runout first.

Measure the runout of the propeller shaft tube at several points by rotating the final drive companion flange with your hands.
Propeller shaft runout limit

2WD : 1.02 mm (0.0402 in) or less

4WD : 0.6 mm (0.024 in) or less

Fig 1: Measuring Runout Of Propeller Shaft
If the runout exceeds specifications, disconnect the propeller shaft at the final drive companion flange; then rotate the companion flange 90°, 180° and 270° and reconnect the propeller shaft.
Check the runout again. If the runout still exceeds specifications, replace the propeller shaft assembly.

Fig 2: Identifying Propeller Shaft Measuring Range
After installation, check for vibration by driving vehicle.