LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2034 (Propeller Shaft) >> Rear Propeller Shaft >> Disassembly and Assembly >> Disassembly >> Journal

Disassembly and Assembly: Disassembly: Journal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Put matching marks on the rear propeller shaft and flange yoke as shown.
    CAUTION: For matching marks use paint. Never damage the rear propeller shaft or flange yoke.
    Fig 1: Identifying Matching Marks On Front Propeller Shaft And Flange Yoke
    G04901785
  2. Remove the snap rings.
    Fig 2: Identifying Snap Ring
    G04901786
  3. Push out and remove the journal bearings by lightly tapping the flange yoke with a hammer, taking care not to damage the journal or flange yoke hole.
    NOTE: Put marks on the disassembled parts so that they can be reinstalled in their original positions from which they were removed.
    Fig 3: Tapping Flange Yoke With Hammer
    G04901787
  4. Push out and remove the remaining journal bearings at the opposite side by lightly tapping the flange yoke with a hammer, taking care not to damage the journal or flange yoke hole.
    NOTE: Put marks on the disassembled parts so that they can be reinstalled in their original positions from which they were removed.
    Fig 4: Tapping Flange Yoke
    G04901788
scientia non olet · About LEMON Manuals