LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2033 (Tires, Wheels & Tire Pressure Monitoring System (TPMS)) >> Wheel And Tire Assembly >> Rotation

Wheel And Tire Assembly: Rotation

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Follow the maintenance schedule for tire rotation service intervals. Refer to "GENERAL MAINTENANCE ".
  1. Remove wheels and tires.
  2. Rotate wheels and tires on each side from front to back as shown. Do not include the spare wheel and tire when rotating the wheels and tires.

    Wheel nut : 133 N.m (14 kg-m, 98 ft-lb) 

    CAUTION: When installing wheels and tires, tighten them diagonally by dividing the work two to three times in order to prevent the wheels from developing any distortion.
    Fig 1: Identifying Tire Rotation
    G04902159
  3. Adjust the tire pressure to specification. Refer to "TIRE ".
  4. After the wheel and tire rotation, retighten the wheel nuts after the vehicle has been driven for 1,000 km (600 miles), and also after any wheel and tire has been installed, such as after repairing a flat tire.
scientia non olet · About LEMON Manuals