LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2033 (Tires, Wheels & Tire Pressure Monitoring System (TPMS)) >> Trouble Diagnoses >> Transmitter Wake Up Operation

Transmitter Wake Up Operation

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure must be done after replacement of a low tire pressure warning transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 before ID registration can be performed.
  1. Turn ignition switch ON. Push the transmitter activation tool against the tire near the front left transmitter. Press the button for 5 seconds. The hazard warning lamps flash per the diagram below.

    Tool number : (J-45295) 

    Fig 1: Identifying Transmitter Activation Tool
    G04902169
  2. Repeat this procedure for each tire in the following order: FL, FR, RR, RL.
  3. When the BCM finishes assigning each tire ID, the BCM flashes the hazard warning lamps and sends flashing indicator status by CAN according to the following time chart.
    Fig 2: Identifying Blinking Pattern
    G04902172
  4. After completing wake up of all transmitters, make sure low tire pressure warning lamp goes out.
scientia non olet · About LEMON Manuals