LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2033 (Tires, Wheels & Tire Pressure Monitoring System (TPMS)) >> Trouble Diagnoses >> ID Registration Procedure >> Id Registration Without Transmitter Activation Tool

Id Registration Without Transmitter Activation Tool

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure must be done after replacement of a low tire pressure warning transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 before ID registration can be performed.
  1. Connect CONSULT-II. Refer to "CONSULT-II START PROCEDURE ".
  2. Select "AIR PRESSURE MONITOR" on "SELECT TEST ITEM" screen.
  3. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
  4. Adjust the tire pressure to the values shown in the table below and drive the vehicle at 15 km/h (9.4 MPH) or more for a few minutes.
    Fig 1: Identifying CONSULT II Display - SELECT DIAG MODE
    G04899604
    TIRE PRESSURE CHART

    Tire position Tire pressure kPa (kg/cm2 , psi)
    Front - Left 250 (2.5, 36)
    Front - Right 230 (2.3, 33)
    Rear - Right 210 (2.1, 30)
    Rear - Left 190 (1.9, 27)
  5. After completing all ID registrations, press "END" to complete the procedure.
    ACTIVATION TIRE POSITION CHART

    Activation tire position CONSULT-II
    Front LH "YET"
    ↓
    "DONE"
    Front RH
    Rear RH
    Rear LH
  6. Inflate all tires to proper pressure. Refer to "TIRE ".
scientia non olet · About LEMON Manuals