Id Registration With Transmitter Activation Tool

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This procedure must be done after replacement of a low tire pressure warning transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 before ID registration can be performed.

Connect CONSULT-II. Refer to "CONSULT-II START PROCEDURE ".
Select "AIR PRESSURE MONITOR" on "SELECT TEST ITEM" screen.
Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".

Fig 1: Identifying CONSULT II Display - SELECT DIAG MODE
Push the transmitter activation tool against the tire near the front left transmitter. Press the button for 5 seconds.
Tool number : (J-45295)

Fig 2: Identifying Transmitter Activation Tool

Register the IDs in order from FR LH, FR RH, RR RH and RR LH. When ID registration of each wheel has been completed, a buzzer sounds and the hazard warning lamps flash.

ACTIVATION TIRE POSITION CHART

Activation tire position		Buzzer	Hazard warning lamp	CONSULT-II
1	Front LH	Once	2 times flashing	"YET" ↓ "DONE"
2	Front RH	2 times
3	Rear RH	3 times
4	Rear LH	4 times

After completing all ID registrations, press "END" to complete the procedure.
NOTE: Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.