Rear Turn Signal Lamp Does Not Operate

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK TAIL LAMPS AND STOP LAMPS
Check bulb standard of each turn signal lamp is correct. Refer to "EXTERIOR LAMP ".

OK or NG

OK: GO TO 2.

NG: Replace turn signal lamp bulb. Refer to "BULB REPLACEMENT ".
CHECK TURN SIGNAL LAMPS CIRCUIT
1. Disconnect BCM connector and rear combination lamp connector.
2. Check continuity between BCM harness connector M20 terminal 61 and rear combination lamp RH harness connector B105 terminal 4.
  61 - 4 : Continuity should exist.
3. Check continuity between BCM harness connector M20 terminal 60 and rear combination lamp LH harness connector B35 terminal 4.
  60 - 4 : Continuity should exist.
  
  Fig 1: Checking Continuity Between BCM Connector Terminal 60 And Rear Combination Lamp Connector Terminal 4
OK or NG

OK: GO TO 3.

NG: Repair harness or connector.
CHECK GROUND CIRCUIT
Check continuity between rear combination lamp harness connector B35 (LH) and B105 (RH) terminal 5 and ground.

5 - Ground : Continuity should exist.

OK or NG

OK: Check rear combination lamp connector for proper connection. Repair as necessary.

NG: Repair harness or connector.

Fig 2: Checking Continuity Between Connector B35 (LH) And B105 (RH) Terminal 5 And Ground