Front Turn Signal Lamps Do Not Operate

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK BULB
Check bulb standard of each turn signal lamp is correct. Refer to "EXTERIOR LAMP ".

OK or NG

OK: GO TO 2.

NG: Replace turn signal lamp bulb. Refer to "FRONT TURN SIGNAL/PARKING LAMP ".
CHECK TURN SIGNAL LAMPS CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM connector and front turn signal lamp LH and RH connectors.
3. Check continuity between BCM harness connector M20 terminal 60 and front turn signal lamp LH harness connector E27 terminal 1.
  60 - 1 : Continuity should exist.
4. Check continuity between BCM harness connector M20 terminal 61 and front turn signal lamp RH harness connector E111 terminal 1.
  61 - 1 : Continuity should exist.
  
  Fig 1: Checking Continuity Between Connector M20 Terminal 61 And Connector E111 Terminal 1
OK or NG

OK: GO TO 3.

NG: Repair harness or connector.
CHECK GROUND
1. Check continuity between front turn signal lamp LH harness connector E27 terminal 3 and ground.
  3 - Ground : Continuity should exist.
2. Check continuity between front turn signal lamp RH harness connector E111 terminal 3 and ground.
  3 - Ground : Continuity should exist.
  
  Fig 2: Checking Continuity Between Connector E111 Terminal 3 And Ground
OK or NG

OK: Inspect connection at front combination lamp.

NG: Repair harness or connector.