Aiming Chart
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
A (Minimum acceptable vertical aim dimension) -3.3 mm (0.13 in) 0.025° up
B (Maximum acceptable vertical aim dimension) 36.6 mm (1.44 in) 0.275° down
NOTE:
- By regulation, no means for horizontal aim adjustment is provided from the factory; only vertical aim is adjustable.
- Basic illuminating area for evaluation and/or adjustment should be within range shown on aiming chart.
- Use adjustment screw to perform aiming adjustment.
- Cover the opposite lamp and ensure fog lamps, if equipped, are turned off. CAUTION: Do not tighten adjustment screw beyond specified torque or damage may occur.
Adjustment torque 1.67 N.m (17 kg-cm, 14.8 in-lb)
- Cover the opposite lamp and ensure fog lamps, if equipped, are turned off.
- Adjust beam pattern until cut-off line (top edge of illumination area) is positioned at the specified height off ground. Measure cut-off line within distance J on H-line. See AIMING CHART .