Removal and Installation of Rear Brake Piping and Brake Hose: Installation
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- Install brake hose by aligning with the protrusion on caliper assembly, and tighten union bolt to the specified torque. Refer to
"HYDRAULIC CIRCUIT ".NOTE: Do not reuse copper washer.
- Insert brake hose end through bracket, then secure it to bracket with lock plate.
- Install brake tube to brake hose, then tighten flare nut to the specified torque using a flare nut wrench.
- Refill brake fluid and bleed air. Refer to "BLEEDING BRAKE SYSTEM ".