LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2029 (Brake System) >> Brake Booster >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be careful not to deform or bend brake piping while removing and installing brake booster.
  • Replace clevis pin if it is damaged.
  • Be careful not to damage brake booster stud bolt threads. If brake booster is tilted or inclined during installation, dash panel may damage the threads.
  • Attach the check valve in the correct direction.
  1. Remove actuator and electric unit. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove brake piping from brake master cylinder.
  3. Remove brake master cylinder. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove vacuum hose from brake booster. Refer to "VACUUM LINES ".
  5. Remove brake pedal attachment snap pin and clevis pin from inside the vehicle.
  6. Remove nuts on brake booster and brake pedal assembly.
  7. Remove brake booster assembly from dash panel.
scientia non olet · About LEMON Manuals