Line Pressure Test Procedure: Notes
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the amount of engine oil and replenish if necessary.
- Drive the car for about 10 minutes to warm it up so that the ATF reaches in range of 50 to 80°C (122 to 176°F), then inspect the amount of ATF and replenish if necessary.NOTE: The automatic fluid temperature rises in range of 50 to 80°C (122 to 176°F) during 10 minutes of driving.
- After warming up remove the oil pressure detection plug and install the oil pressure gauge [ST2505S001(J-34301-C)].CAUTION: When using the oil pressure gauge, be sure to use the O-ring attached to the oil pressure detection plug.
- Securely engage the parking brake so that the tires do not turn.
- Start the engine, then measure the line pressure at both idle and the stall speed.CAUTION:
- Keep the brake pedal pressed all the way down during measurement.
- When measuring the line pressure at the stall speed, refer to "STALL TEST ".
- After the measurements are complete, install the oil pressure detection plug and tighten to the regulation torque below.
: 7.3 N.m (0.74 kg-m, 65 in-lb)
CAUTION:- Do not reuse the O-ring.
- Apply ATF to O-ring.