Cruise Test - Part 2
- CHECK STARTING FROM D1
- Move selector lever to "D" position.
- Accelerate at half throttle.
With CONSULT-II
Read the gear position.
Does it start from D1?
YES: GO TO 2.
NO: Enter a check mark at "Vehicle Cannot Be Started From D1" on the diagnostics worksheet, then continue the road test.
- CHECK SHIFT-UP D1 --> D2
Press the accelerator pedal down all the way and inspect whether or not the transmission shifts up (D1 --> D2) at the correct speed.
- Refer to "VEHICLE SPEED AT WHICH GEAR SHIFTING OCCURS ".
With CONSULT-II
Read the gear position, throttle position and vehicle speed.
Does the A/T shift-up D1 --> D2 at the correct speed?
YES: GO TO 3.
NO: Enter a check mark at "A/T Does Not Shift: D1 --> D2" on the diagnostics worksheet, then continue the road test.
- CHECK SHIFT-UP D2 --> D3
Press the accelerator pedal down all the way and inspect whether or not the transmission shifts up (D2 --> D3) at the correct speed.
- Refer to "VEHICLE SPEED AT WHICH GEAR SHIFTING OCCURS ".
With CONSULT-II
Read the gear position, throttle position and vehicle speed.
Does the A/T shift-up D2 --> D3 at the correct speed?
YES: GO TO 4.
NO: Enter a check mark at "A/T Does Not Shift: D2 --> D3" on the diagnostics worksheet, then continue the road test.
- CHECK SHIFT-UP D3 --> D4 AND ENGINE BRAKE
When the transmission changes speed D3 --> D4, return the accelerator pedal.
With CONSULT-II
Read the gear position.
Does the A/T shift-up D3 --> D4 and apply the engine brake?
YES:
- Stop the vehicle.
- See "CRUISE TEST - PART 3 ".
NO: Enter a check mark at "A/T Does Not Shift: D3 --> D4" on the diagnostics worksheet, then continue the road test.