Mid Sun Gear, Rear Sun Gear, High and Low Reverse Clutch Hub: Assembly

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Install seal rings to mid sun gear.
CAUTION:
- Do not reuse seal rings.
- Apply petroleum jelly to seal rings.
  
  Fig 1: Identifying New Seal Rings To Mid Sun Gear
Install 1st one-way clutch to rear sun gear.
CAUTION: Apply petroleum jelly to 1st one-way clutch.

Fig 2: Identifying 1st One-Way Clutch To Rear Sun Gear
Install snap ring to rear sun gear using suitable tool.

Fig 3: Identifying Snap Ring To Rear Sun Gear
Install rear sun gear assembly to mid sun gear assembly.

Fig 4: Identifying Rear Sun Gear Assembly
Install needle bearing to high and low reverse clutch hub.
CAUTION: Apply petroleum jelly to needle bearing.

Fig 5: Applying Petroleum Jelly To Needle Bearing
Install high and low reverse clutch hub to mid sun gear assembly.

Fig 6: Identifying High And Low Reverse Clutch Hub To Mid Sun Gear Assembly
Install snap ring to mid sun gear assembly using suitable tool.
CAUTION: Do not excessively expand snap ring.

Fig 7: Identifying Snap Ring
Check operation of 1st one-way clutch.
1. Hold mid sun gear and turn rear sun gear.
2. Check 1st one-way clutch for correct locking and unlocking directions.
  CAUTION: If not as shown, check installation direction of 1st one-way clutch.
  
  Fig 8: Checking 1st One-Way Clutch For Correct Locking And Unlocking
Install needle bearing and bearing race to high and low reverse clutch hub.
CAUTION: Apply petroleum jelly to needle bearing and bearing race.

Fig 9: Identifying Needle Bearing And Bearing Race