With Consult-II
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- Start engine.
- Accelerate vehicle to maintain the following conditions.
Selector lever: "1" or "2" position
Gear position: "1st" or "2nd" gear (LC/B ON/OFF)
- Perform step "2" again.
- Turn ignition switch "OFF", then perform step "1" to "3" again.
- Check "SELF-DIAG RESULTS" mode for "A/T" with CONSULT-II. If DTC (P1774) is detected, refer to
"DIAGNOSTIC PROCEDURE ".
If DTC (P1772) is detected, go to "DIAGNOSTIC PROCEDURE ".