LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2019 (Front Final Drive) >> Front Oil Seal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive shafts from the front final drive assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the front propeller shaft from the front final drive assembly. Refer to "REMOVAL AND INSTALLATION ".
  3. Measure the total preload torque. Refer to "TOTAL PRELOAD TORQUE ".
    NOTE: Record the total preload torque measurement.
  4. Remove the drive pinion lock nut using Tool.

    Tool number : KV38108300 ( - ) 

    Fig 1: Removing Drive Pinion Lock Nut Using Tool
    G04901826
  5. Put matching marks on the companion flange and drive pinion using paint.
    CAUTION: Use paint to make the matching marks. Do not damage the companion flange or drive pinion.
  6. Remove the companion flange using suitable tool.
    Fig 2: Identifying Companion Flange
    G04901827
  7. Remove the front oil seal using Tool.

    Tool number : KV381054S0 (J-34286) 

    Fig 3: Identifying Front Oil Seal
    G04898675
scientia non olet · About LEMON Manuals