LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2016 (Engine Cooling System) >> Water Inlet And Thermostat Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Completely drain engine coolant. Refer to "DRAINING ENGINE COOLANT ".
    CAUTION:
    • Perform this step when engine is cold.
    • Do not spill engine coolant on drive belts.
  2. Remove air duct and air cleaner case. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect radiator hose (lower) and oil cooler hose from water inlet and thermostat assembly.
  4. Remove water inlet and thermostat assembly.
    CAUTION: Do not disassemble water inlet and thermostat assembly. Replace them as a unit, if necessary.
    Fig 1: Identifying Water Inlet And Thermostat Assembly
    G04874752
scientia non olet · About LEMON Manuals