LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2015 (Engine Mechanical) >> Rocker Cover >> Removal and Installation >> Removal (Right Bank)

Removal (Right Bank)

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove intake manifold collector. Refer to "REMOVAL ".
    CAUTION: Perform this step when engine is cold.
  2. Separate engine harness removing their brackets from rocker covers.
  3. Remove harness bracket from cylinder head (right bank). Refer to "CYLINDER HEAD ".
  4. Remove ignition coil. Refer to "REMOVAL AND INSTALLATION ".
  5. Remove PCV hoses from rocker cover.
  6. Remove PCV valve and O-ring from rocker cover (right bank), if necessary.
  7. Loosen bolts with power tool in reverse order as shown below.
    Fig 1: Rocker Cover Bolts (With Tightening Sequence)
    G04894031Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Remove rocker cover gaskets from rocker covers.
  9. Use scraper to remove all traces of liquid gasket from cylinder head and camshaft bracket (No. 1).
    CAUTION: Do not scratch or damage the mating surface when cleaning off old liquid gasket.
scientia non olet · About LEMON Manuals