Cylinder Head Distortion
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When performing this inspection, cylinder block distortion should be also checked. Refer to
"CYLINDER BLOCK DISTORTION ".
- Using suitable tool, wipe off oil, scale, gasket, sealant and carbon deposits from surface of cylinder head.CAUTION: Do not allow gasket fragments to enter engine oil or engine coolant passages.
- At each of several locations on bottom surface of cylinder head, measure the distortion in six directions.
Limit : 0.1 mm (0.004 in)
- If it exceeds the limit, replace cylinder head.