Inspection Procedure

1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
   • Harness connector M91
   • Harness connector E26

OK or NG 

OK: GO TO 2.

NG: Repair the terminal and connector.

1. Disconnect the following harness connectors.
   • Display control unit connector
   • Harness connector M91 and E26
2. Check the continuity between the display control unit harness connector and the harness connector.
   TERMINALS CONTINUITY REFERENCE
   
   

   Display control unit harness connector		Harness connector		Continuity
   Connector No.	Terminal No.	Connector No.	Terminal No.
   M95	25	M91	11	Yes
   	26		10	Yes

OK or NG 

OK: GO TO 3.

NG: Repair the main line between the display control unit and the harness connector M91.

1. Disconnect the connector of ABS actuator and electric unit (control unit).
2. Check the continuity between the harness connector and the ABS actuator and electric unit (control unit) harness connector.
   TERMINALS CONTINUITY REFERENCE
   
   

   Harness connector		ABS actuator and electric unit (control unit) harness connector		Continuity
   Connector No.	Terminal No.	Connector No.	Terminal No.
   E26	11	E125	11	Yes
   	10		15	Yes

OK or NG 

OK:

• Present error: Check the following items again.
  • Decision of CAN system type.
  • Not received CONSULT-II data (SELECT SYSTEM, SELF-DIAG RESULTS, CAN DIAG SUPPORT MNTR).
  • Not copied from on-board diagnosis.
  • Procedure for detecting root cause.
• Past error: Error was detected in the main line between the display control unit and the ABS actuator and electric unit (control unit).

NG: Repair the main line between the harness connector E26 and the ABS actuator and electric unit (control unit).