Inspection Flow

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CONFIRM SYMPTOM BY PERFORMING OPERATIONAL CHECK - TEMPERATURE INCREASE
1. Press AUTO switch (rear blower only operates when front blower is on).
2. Turn the rear blower motor on (1-4 speed).
3. Turn the rear temperature/mode control dial clockwise.
4. Check for hot air at rear foot discharge air outlets.
  GO TO 2.
CONFIRM SYMPTOM BY PERFORMING OPERATIONAL CHECK - TEMPERATURE DECREASE
1. Turn the rear temperature/mode control dial counterclockwise.
2. Check for cold air at rear vent discharge air outlets.
OK or NG

OK: GO TO 3.

NG: GO TO 4.
CHECK FOR ANY SYMPTOMS
Perform a complete operational check for any symptoms. Refer to "OPERATIONAL CHECK (FRONT) ".

Does another symptom exist?

YES: Refer to "SYMPTOM TABLE ".

NO: System OK.
CHECK FOR SERVICE BULLETINS
Check for any service bulletins.

GO TO 5.
PERFORM SELF-DIAGNOSIS
Perform self-diagnosis to check for any codes. Refer to "A/C SYSTEM SELF-DIAGNOSIS FUNCTION ".

Are any self-diagnosis codes present?

YES: Refer to "SELF-DIAGNOSIS CODE CHART ".

NO: GO TO 6.
CHECK REAR TEMPERATURE/MODE CONTROL DIAL OPERATION
Check and verify rear outlet position and temperature change when adjusted from front air control.

OK or NG?

OK: Check rear air control circuit. Refer to "DIAGNOSTIC PROCEDURE FOR REAR AIR CONTROL ".

NG: Check air mix door motor (rear). Refer to "DIAGNOSTIC PROCEDURE FOR AIR MIX DOOR MOTOR (REAR) ".