Cruise Test - Part 2
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK STARTING FROM D1
- Move selector lever the "D" position.
- Accelerate at half throttle.
With CONSULT-II
Read the gear position.
Does it start from D1?
- YES : GO TO 2.
- NO : Enter a check mark at "Vehicle cannot be started from D1" on the diagnostics worksheet, then continue the road test.
- CHECK SHIFT-UP D1 --> D2
Press the accelerator pedal down all the way and inspect whether or not the transaxle shifts up (D1 --> D2) at the correct speed.
- Refer to SHIFT SCHEDULE .
With CONSULT-II
Read the gear position, accelerator angle and vehicle speed.
Does the A/T shift-up D1 --> D2 at the correct speed?
- YES : GO TO 3.
- NO : Enter a check mark at "A/T does not shift D1 --> D2" on the diagnostics worksheet, then continue the road test.
- CHECK SHIFT-UP D2 --> D3
Press the accelerator pedal down all the way and inspect whether or not the transaxle shifts up (D2 --> D3) at the correct speed.
- Refer to SHIFT SCHEDULE .
With CONSULT-II
Read the gear position, accelerator angle and vehicle speed.
Does the A/T shift-up D2 --> D3 at the correct speed?
- YES : GO TO 4.
- NO : Enter a check mark at "A/T does not shift D2 --> D3" on the diagnostics worksheet, then continue the road test.
- CHECK SHIFT-UP D3 --> D4 AND ENGINE BRAKE
When the transaxle changes speed D2 --> D3, return the accelerator pedal.
Does the A/T shift-up D3 --> D4 and apply the engine brake?
- YES :
- Stop the vehicle.
- Go to CRUISE TEST - PART 3 .
- NO : Enter a check mark at "A/T does not shift D3 --> D4" on the diagnostics worksheet, then continue the road test.
- YES :