How to erase Diagnostic Trouble Codes (no tools)
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
The O/D OFF indicator lamp is located on the instrument panel.
- If the ignition switch stays "ON" after repair work, be sure to turn ignition switch "OFF" once. Wait at least 10 seconds and then turn it "ON" (engine stopped) again.
- Erase DTC with TCM. Refer to ERASE SELF-DIAGNOSIS . (The engine warm-up step can be skipped when performing the diagnosis only to erase the DTC.)
- Erase DTC with ECM. Refer to HOW TO ERASE DIAGNOSTIC TROUBLE CODES .