Diagnostic Procedure

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CAN COMMUNICATION CIRCUIT
1. Turn ignition switch "ON" and start engine.
2. Select "SELF-DIAG RESULTS" mode for "TRANSMISSION" with in CONSULT-II.
  
  Fig 1: CONSULT-II Display - SELECT SYSTEM
  Courtesy of NISSAN MOTOR CO., U.S.A.
3. The "CAN COMM CIRCUIT" is detected.
Yes or No?
- Yes : Print out CONSULT-II screen, GO TO PRECAUTIONS WHEN USING CONSULT-II .
- No : INSPECTION END