With Consult-II

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch "ON". (Do not start engine.)
Select "DATA MONITOR" mode for "A/T" with CONSULT-II.

Fig 1: CONSULT-II Display - SELECT SYSTEM
Courtesy of NISSAN MOTOR CO., U.S.A.
Start engine.
Drive vehicle and allow the following conditions.
SLCT LVR POSI: "D" position

GEAR: 2nd => 3rd position
If DTC is detected, go to DIAGNOSTIC PROCEDURE .