Removal and Installation: Removal
WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Never apply tack-paper adhesive remover to body panel surface finished with lacquer-based paints.
- Original side guard molding is affixed to body panel with double-faced adhesive tape.
- Heat molding to between 30° and 40°C (86° to 104°F) with a heat gun.
- Raise end of molding and cut away tape to remove molding.
- Remove all traces of tape.