Sunroof Unit: Installation
WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Temporarily tighten the mounting bolts on the rear sunroof brackets.
- Bring sunroof unit into passenger compartment and place the rear end of the rail onto the rear sunroof brackets.
- Temporarily tighten the mounting bolts on the front end.
- Tighten the installation point bolts diagonally excluding the installation point of the sunroof bracket around the roof opening.
- Tighten the bolts on the front sunroof bracket at the vehicle side and then at the rail side.
- Tighten the bolts on the rear sunroof bracket at the vehicle side and then at the rail side.
Sunroof assembly mounting bolts
Sunroof assembly front: 5.10 - 6.47 N.m (0.52 - 0.66 kg-m, 46 - 57 in-lb) end bolts
Sunroof assembly side: 5.10 - 6.47 N.m (0.52 - 0.66 kg-m, 46 - 57 in-lb) rail bolts
Sunroof assembly front: 5.10 - 6.47 N.m (0.52 - 0.66 kg-m, 46 - 57 in-lb) bracket bolts
Sunroof assembly rear: 5.10 - 6.47 N.m (0.52 - 0.66 kg-m, 46 - 57 in-lb) bracket bolts
- Connect drain hoses.
- Install headlining. Refer to EXTERIOR & INTERIOR , "Headlining".