Gap Adjustment
WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If any gap or height difference between glass lid and roof is found, check glass lid fit and adjust as follows:
- Open sunshade assembly.
- Tilt glass lid up then remove side trim.
- Loosen glass lid securing nuts (2 each on left and right sides) then tilt glass lid down.
- Manually adjust glass lid from outside of vehicle so it resembles "A-A" as shown in the figure above.
- Tilt glass lid up and down until it is adjusted to "B-B" (when sunroof is closed) as shown in the figure above.
- After adjusting glass lid, tilt glass lid up and tighten nuts.
- Tilt glass lid up and down several times to check that it moves smoothly.
NOTE:
First tighten left front nut, then tighten right rear nut on glass lid to prevent lid from moving while tighten other nuts.