Striker Adjustment
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Turn OFF automatic sliding door system, if equipped.
- Inspect the door latch-to-striker clearance for the front and rear strikers.
- Slowly open and close the sliding door.
- Confirm the strikers meet the latches correctly.
- Adjust striker height up or down as needed.
- Slightly loosen the door strikers, upper and lower dovetails, and contact switch.NOTE: Loosened parts should not move on their own.
- Open and close the door three or four times to allow the strikers and contact switch to align themselves.
- Carefully tighten all loosened parts using care not to move the parts.
- Open and close door three or four times to confirm smooth latching.