Diagnostic Procedure 7
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK METER FUSE
Check the 10A fuse [No. 14, located in the fuse block (J/B)].
Refer to "POWER SUPPLY ROUTING CIRCUIT ".
OK or NG
- OK: GO TO 3.
- NG: GO TO 2.
- CHECK METER FUSE AGAIN
Replace 10A fuse [No. 14, located in the fuse block (J/B)] and turn ignition switch ON.
Does the fuse blow again?
- Yes: Repair the related harness.
- No: Inspection End.
- CHECK HARNESS CONNECTION BETWEEN DIAGNOSIS SENSOR UNIT AND COMBINATION METER
Disconnect the air bag diagnosis sensor unit harness connectors and turn ignition switch ON
Does "AIR BAG" warning lamp turn on?
- Yes: Replace the air bag diagnosis sensor unit. Refer to "REMOVAL AND INSTALLATION ".
- No: Check the combination meter ground circuits.