How To Initiate Combination Meter Self-Diagnosis Mode
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Once entered, Combination Meter Self-Diagnosis Mode will function with the ignition switch in ON or START. Combination Meter Self-Diagnosis Mode will exit upon turning the ignition switch to OFF. To initiate Combination Meter Self-Diagnosis Mode, refer to the following procedure.
- Turn ignition switch and high beam headlamps OFF.
- Apply brake pedal and turn ignition switch ON.
- Within 3 seconds of turning ignition switch ON, engage flash to pass and hold for 5 to 8 seconds.
NOTE:
If the self-diagnosis function is activated, the odometer/trip meter will display test.