Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear wheel and tire using power tool.
Reposition the brake caliper assembly out of the way with a suitable wire without disconnecting the hydraulic hose, using power tool. Refer to "REMOVAL AND INSTALLATION OF CALIPER ASSEMBLY AND DISC ROTOR "
- The brake hose should not be disconnected from the brake caliper.
- Suspend the caliper assembly using a suitable wire so that the brake hose is not stretched.
  CAUTION:
  - Do not depress the brake pedal to prevent the caliper piston from popping out.
  - Do not twist the brake hose.
Remove the brake rotor.
NOTE: The parking brake must be fully released.
Remove the rear ABS sensor, then position it away from the hub assembly using wire. Refer to "WHEEL SENSORS - WITH TCS/ABS " (TCS/ABS), "WHEEL SENSORS - WITH VDC/TCS/ABS " (VDC/TCS/ABS).
CAUTION:
- Failure to remove the rear ABS sensor may result in damage to the sensor, causing the sensor to become inoperative.
- Do not stretch the rear ABS sensor wire harness.
Remove the wheel hub assembly from the knuckle using power tool.