With CONSULT-II
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition witch ON and wait at least 1 second.
- Select "DATA MONITOR" mode with CONSULT-II.
- Shift selector lever to D position, and wait at least 3 seconds.
- Shift selector lever to P position.
- Turn ignition witch OFF and wait at least 10 second.
- Turn ignition witch ON and wait at least 1 second.
- Shift selector lever to D position, and wait at least 3 seconds.
- Shift selector lever to P position.
- Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
- If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".