With Consult-II

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.

Fig 1: CONSULT-II Data Monitor Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Start engine and let it idle for 1 second.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and wait at least 1 second.
Repeat step 2 to 4 for 4 times.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "