Check "L" Terminal Circuit

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK "L" TERMINAL CONNECTION
Check to see if "L" terminal is clean and tight.

OK or NG
- OK: GO TO 2.
- NG: Repair "L" terminal connection. Confirm repair by performing complete Battery/Starting/Charging system test.
CHECK "L" TERMINAL CIRCUIT
1. Disconnect F1 connector from generator.
2. Apply ground to connector F1 terminal L (BR/Y) with the ignition switch in the ON position.
  
  Fig 1: Applying Ground To Connector Terminal L
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  CHARGE lamp should light up.
OK or NG
- OK: GO TO "WORK FLOW ".
- NG: Check the following.
  - 10A fuse [No. 14, located in fuse block (J/B)]
  - CHARGE lamp
  - Harness for open or short between combination meter and fuse
  - Harness for open or short between combination meter and generator