Malfunction Code No. 21, 22, 23 Or 24
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONTROL UNIT
Drive for several minutes. Check all tire pressures with CONSULT-II "DATA MONITOR ITEM".
Are all tire pressures displayed as 0 kPa?
- YES: GO TO 2.
- NO: GO TO 3.
- CHECK REMOTE KEYLESS ENTRY RECEIVER CONNECTOR
Check remote keyless entry receiver connector for damage or loose connections.
OK or NG
- OK: Replace BCM, then GO TO 3. Refer to REMOVAL AND INSTALLATION OF BCM .
- NG: Repair or replace remote keyless entry receiver connector.
- ID REGISTRATION
Carry out ID registration of all transmitters.
Is there a tire that cannot register ID?
- YES: Replace transmitter of the tire, then GO TO 5.
- NO: GO TO 4.
- VEHICLE DRIVING
- Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
- Check all tire pressures with CONSULT-II "DATA MONITOR ITEM" within 15 minutes after vehicle speed becomes 17 km/h (11 MPH).
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
- YES: Inspection End.
- NO: GO TO 5.
- ID REGISTRATION AND VEHICLE DRIVING
- Carry out ID registration of all transmitters.
- Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes. Then check all tire pressures with CONSULT-II "DATA MONITOR ITEM" within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
- YES: Inspection End.
- NO: GO TO the inspection applicable to DTC.