System Description: Notes

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Wiper switch (combination switch) is composed of a combination of 5 output terminals and 5 input terminals. Terminal combination status is read by BCM (body control module) when switch is turned ON.
BCM controls rear wiper ON and INT (intermittent) operation.

Power is supplied at all times

through 50A fusible link (letter j, located in fuse and fusible link box)
to BCM terminal 55.

With the ignition switch in ON or START position, power is supplied

through 10A fuse [No. 16, located in fuse block (J/B)]
to BCM terminal 38, and
through 10A fuse (No. 47, located in IPDM E/R)
through IPDM E/R terminal 44
to combination switch terminal 14.

Ground is supplied

to BCM terminal 52 and
to combination switch terminal 12
through grounds M57, M61 and M79.